MIL-DTL-55353A
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-130
-
Identification Marking of U.S. Military Property.
MIL-STD-202
-
Test Methods Standards Electronic and Electrical Component Parts.
MS75105
-
HB-7 Headband Assembly).
MS75127
-
Earphone Assembly.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from
the Defense Automated Printing Service, Building 4D (DPM-DODSSP), 700 Robbins Avenue, Philadelphia, PA
19111-5094.)
*
2.3 Non-Government publications. The following documents form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the
issue of the DoDISS cited in the solicitation. Unless otherwise specified, the issues of documents not listed in the
DoDISS are the issues of the documents cited in the solicitation.
INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)
ISO-10012-1
-
Quality Assurance Requirements for Measuring Equipment. Metrological
Confirmation System for Measuring Equipment
(Application for copies should be addressed to American National Standards Institute (ANSI),
nd
11 West 42 Street, New York, NY 10036)
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
Z540-1
-
Calibration Laboratories and Measuring and Test Equipment - General
Requirements.
(DoD activities may obtain copies of this standard from the Defense Printing Service Detachment Office, Building
4D, Customer Service, 700 Robbins Avenue, Philadelphia, PA 19111-5094. Private sector and other Government
Agencies may purchase copies from ANSI.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws
and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. Materials shall be as specified herein. However, when a definite material is not specified, a
material shall be used which will enable the headsets to meet the performance requirements of this specification.
Acceptance or approval of any constituent material shall not be construed as a guaranty of the acceptance of the
finished product.
3.1.1 Metals. The metals used shall be of proper alloy and hardness necessary to provide the required strength
and rigidity with the maximum strength to weight ratio. Metals shall be of a corrosion-resistant type and shall be
treated in accordance with MIL-F-14072, type II (sheltered).
3.1.2 Insulation. Insulation shall be in accordance with MIL-I-631.
3.2 Interface and dimensions. The headset shall be in accordance with figure 1.
3.2.1 Wiring. The earphones shall be wired in series.
3.3 Performance characteristics.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business