MIL-DTL-11193E
DRAWINGS
ARMY DRAWINGS
SC-B-22581
-
Spring
SC-B-60159
-
Wire assembly
SC-B-68419
-
Bushing
SC-B-68422
-
Washer
SC-B-68426
-
Stud
SC-B-83087
-
Switch assembly
SC-B-74475
-
Lead assembly
SC-C-77023
-
Microphone M-51/UR
SC-D-60157
-
Case assembly
SC-D-60158
-
Cord assembly
SC-D-74472
-
Microphone, carbon M-52A/U assembly
SC-D-74473
-
Case assembly
SC-D-74474
-
Cable assembly
SM-B-96093
-
Spring
SM-B-96094
-
Washer
SM-B-96095
-
Holder
SM-B-96096
-
Insulator
SM-C-96099
-
Boot
SM-B-96100
-
Plate
SC-DL-69010
-
Cover, microphone CW-292/U
SC-DL-76334
-
Microphone M-52( )/U
SC-DL-85584
-
Microphone M-29( )/U
(Copies of these documents are available online at https://www.dscc.dla.mil/programs/milspec/ or from the Defense
Supply Center Columbus, ATTN: VAI, P.O. Box 3990, Columbus, Ohio 43218-3990.)
2.3 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the
text of this document and the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIRMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection in accordance with
4.2.
3.1.1 Description of microphones. Microphone M-29( )/U and Microphone M-52( )/U are hand held noise
canceling type microphones for general purpose use. Microphone M-29( )/U is equipped with a five conductor
retractile type cord terminated in ten pin connector. Microphone M-52( )/U is equipped with a three conductor, non-
retractile type cord terminated in a telephone type plug.
3.2 Construction.
a. Microphone M-29( )/U. Construction of Microphone M-29( )/U shall be in accordance with drawing data list
SC-DL-85584 and on figure 1.
b. Microphone M-52( )/U. Construction of Microphone M-52( )/U shall be in accordance with drawing data list
SC-DL-76334 and on figure 2.
3.2.1 Pure tin. The use of pure tin, as an underplate or final finish, is prohibited both internally and externally. Tin
content of handsets and components and solder shall not exceed 97 percent, by mass. Tin shall be alloyed with a
minimum of 3 percent lead, by mass (see 6.5)
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business