MIL-DTL-12606E
STANDARDS
FEDERAL
FED-STD-H28
-
Screw-Thread Standards for Federal Service.
FED-STD-595
-
Colors.
DEPARTMENT OF DEFENSE
MIL-STD-202
-
Test Method Standard, for Electronic and Electrical Component Parts.
MIL-STD-1344
-
Test Methods for Electrical Connectors.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of documents, which are DoD adopted, are those listed in the issue DoDISS cited in the solicitation.
Unless otherwise specified, the issues of documents not listed in the DoDISS are the issues of the documents cited in the solicitation
(see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/Y14.5
-
Dimensioning and Tolerancing.
ANSI-Z540-1
-
Calibration Laboratories and Measuring and Test Equipment General Requirement.
(Applications for copies should be addressed to the American National Standards Institute, Inc., 1430 Broadway, New York, N.Y.
10017).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM B152
-
Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar.
(Applications for copies should be addressed to the American Society for Testing and Materials, 100 Barr Harbor Dr., West
Conshohocken, PA 19428-2959).
INSTITUTE OF ELECTRICAL AND ELECTRONIC ENGINEERS (IEEE)
Standard 219
-
Loudspeaker Measurements, Recommended Practice For.
(Applications for copies should be addressed to the Institute of Electrical and Electronic Engineers (IEEE), Service Center, Post Office
Box 1331, 445 Hoes Lane, Piscataway, NJ 08654-1331.)
INTERNATIONAL ORGANIZATION FOR STANDARDS (IOS)
ISO-10012-1
-
Quality Assurance Requirements for Measuring Equipment, Metrological Confirmation System for
Measuring Equipment.
nd
(Application for copies should be addressed to American National Standards Institute (ANSI), 11 West 42 Street, New York, NY
10036.)
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA-MW10001
-
Magnet Wire.
(Application for copies should be addressed to Global Engineering Documents, 15 Inverness Way East, Englewood, CO 80112-5776.)
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the
documents. These documents also may be available in or through libraries or other informational services.)
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business