MIL-DTL-12606E
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of this specification.
b.
Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual documents referenced
(see 2.1).
c.
Packaging requirements (see 5.1).
d.
Applicable document for classification of visual and mechanical defects if other than table VI (see 4.7.1).
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products which are, at the time of
award of contract, qualified for inclusion in the applicable Qualified Products List QPL-12606, whether or not such products have actually
been so listed by that date. The attention of the contractors is called to this requirement, and manufacturers are urged to arrange to have
the products that they propose to offer to the Federal Government tested for qualification in order that they may be eligible to be awarded
contracts for the products covered by this specification. The activity responsible for the qualified products lists is the Defense Supply
Center Columbus (DSCC-VQP), 3990 East Broad Street, Columbus, Ohio 43216-5000.
6.4 Acceptable loudspeaker design. Figure 8 shows an example of an acceptable loudspeaker design.
6.5 Test cabinet. In lieu of the test cabinet specified on figure 7, a cabinet assembly conforming to MIL-L-12632 may be used at the
option of the manufacturer.
6.6 Typical. As defined in ANSI Y14.5, the term "typical" means that the dimension or feature applies to the locations that appear to
be identical in size and configuration. The tolerance, stated for a dimension labeled "typical", also applies to each identical feature.
6.7 Part or Identifying Number (PIN). The PIN consists of the letter "M" followed by the basic number of this specification (or
specification sheet) and a dash number added as follows:
M12606
-
01
Basic spec number
Dash number
6.8 M12606-02. M12606-02 and LS-445/U are identical, except the M12606-02 has captive mounting screws, a rubber gasket, and a
front grill, which overlaps the front of the speaker body.
6.9 Subject term (key word) listing.
Analyzer, sound wave
Basket
Coil, voice
Distortion, harmonic
Piece, pole
Screen
Source, signal
Spider
Quality, acoustic
6.10 Changes from previous issue. The margins of this specification are marked with asterisks to indicate where changes from the
previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based upon the
entire content, regardless of the marginal notations and relationship to the last previous issue.
20
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business